![]() ![]() This is another step where slow and steady is the way to go - I found that pouring a little glitter onto the bottom of my tumbler and then tapping the side of it helped a lot to fall in, and then could use some craft tweezers to push the rest through. You want to slowly add the glitter to your tumbler by pushing it into the hole you've made in the base. It's not the most technical way of doing things, but it works! Step 3. ![]() I found the easiest way to do this was by taking a small craft knife blade and running it around the edge to remove the 'fluffy' bits of acrylic and then turn the tumbler the right way up and shake it until any other little bits of acrylic fall out. Now that we've made a hole in our bottle, we need to clean up the edges and also remove any acrylic debris that's fallen inside. It can be worth going back in with a larger drill bit and widening the hole slightly, especially if you're planning to use a chunky or shaped glitter. Keep an eye on how far you are, as you don't want to break through the outer wall and then accidentally crack or drill through the inner wall. Once you can see that you're starting to make a dent in the acrylic, you can apply a bit more pressure and speed to the drill. Slow and steady is the key with this, so you want to go in at a low speed and not too much pressure to start - if you press too hard, the point of the drill bit can crack the acrylic. The first step in this DIY project is to drill a hole in the outside wall of our double-walled tumbler so that we will be able to add the glitter. ![]() This tutorial has the potential to get a bit messy, so I'd suggest working on a wipe-clean surface or putting down some scrap paper to collect any rogue glitter. You can download them now and get crafting immediately.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |